The Amphenol NMEA2000 terminator is used to correctly terminate an onboard NMEA 2000 backbone. An NMEA 2000 network normally requires a 120 Ohm terminator at both ends of the backbone to keep data communication stable and prevent network faults.
This terminator is suitable for marine NMEA 2000 installations using Micro-C/M12 5-pin connectors. Depending on the version, a male or female terminator is used at the end of the backbone. Always check which connector is available on your T-piece, backbone cable or distribution block before ordering.
Key features
- NMEA 2000 network terminator
- Available/used as male or female version, depending on network side
- For terminating an NMEA 2000 backbone
- 120 Ohm termination resistor
- Micro-C / M12 5-pin connector version
- Screw thread coupling for secure installation
- IP68 mated rating according to Amphenol datasheet
- NMEA 2000 certified connector series according to Amphenol datasheet
- Suitable for onboard marine electronics
- Can be used in networks with chartplotters, AIS, GPS, sensors, displays and engine data
- Normally two terminators are used per NMEA 2000 backbone
- Not intended as a standard cable connector or T-piece
- Always check male/female connector type before ordering
